Zodiac TRI CHLORINE GENERATOR Instruction Manual download pdf (Page 9)

PREPARING PH SENSOR

1. Identify a straight section of horizontal pipe of appropriate

length after the ﬁ lter but before the salt cell (30 cm is

recommended).

2. Disassemble sensor POD to get lower part of POD clamp

with 2 holes (picture1).

3. Place the lower part of POD clamp upside down into position

on the selected length of piping

4. Now mark the location of the 2 holes to be made into piping

using a pencil or marker (picture 2).

5. Drill the 2 holes using the provided hole saw. Ensure that

holes are perfectly smooth around the edges (picture 3).

6. Position the upper part of POD clamp by sliding it into the 2

previously drilled holes (picture 4).

Warning: Arrows on upper part of POD clamp

indicate direction of water ﬂ ow

7. Interlock the lower part of POD clamp onto the upper part

already in place on piping. (if using 40mm pipe use the spacer

provided)

8. Fit the POD cap on top of upper POD clamp, re-ﬁ t locking

ring and tighten ﬁ rmly using provided tool.

9. Install the pH sensor by ﬁ rmly screwing into the POD cap.

10. Connect the sensors with the provided cable to the

appropriate sockets on the TRi power pack.

Ensure ﬂ ow arrows are in

the correct

Smooth edges

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

No comments

Zodiac TRI CHLORINE GENERATOR Instruction Manual Page 9