Zodiac V3 4WD User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
H03818-00.A3 EN 2012-03 7
• Remove the cleaner from the pool
after the cleaning cycle is completed
and store on the caddy.
• Never lift the cleaner out of the pool
by the floating cable. Always use the
handle to remove it from the pool.
3. Maintenance
3.1 Cleaning the filter bag
To avoid electric shock and other hazards which could result in permanent injury or death, disconnect
(unplug) the cleaner from the control unit before performing any cleaning and maintenance.
The filter canister should be cleaned at the end of each cycle.
Ensure that the control unit cable has been disconnected from the electrical outlet or that the floating cable has
been disconnected from the control unit.
Remove the cleaner from the water and let the remaining water drain by maintaining the cleaner in the vertical
position.
Set the unit on its wheels.
Push the cover lock (1) and lift the cover (2) until it is secured in the vertical position (Figure 1).
Remove the filter assembly from the body (3) (Figure 2).
Push the quick release button on the canister assembly (4) and pull open the filter assembly (5) (Figure 3).
Separate the filter canister from the filter support (6) (Figure 4).
Wash the filter canister, the filter support, and the cleaner under water or using a
hose (7) (Figure 5).
Approximately 15 minutes after the cycle is completed, the light located on the control unit will flash
slowly to indicate that the cleaner may be removed from the pool. The 15 minute period allows the
motor to cool and will prevent damage to the cleaner.
Remove the cleaner from pool when super chlorinating.
• Do not handle cleaner while it is in operation.
• Use your cleaner as often as needed to keep your pool clean.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a permanent basis.
• At the end of each cycle, remove the cleaner from the pool. Start at the cleaner head and untangle
any coils in the hose before storing the cleaner.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments