PLAYBACK
Playing back tunes from Bluetooth™ components
En 71
5
Make sure the Bluetooth component
recognizes the Bluetooth wireless audio
receiver.
When the device is recognized, it will appear in the
Bluetooth component list, for example as “YBA-10
YAMAHA.”
6
Select the Bluetooth wireless audio receiver
from the Bluetooth component list, and
enter a pass key “0000” into the Bluetooth
component. J1
Using Bluetooth™ components
When pairing is complete, perform the following
procedure to achieve a wireless connection between this
unit and the Bluetooth component. When the wireless
connection is complete, Bluetooth components can be
played back.
1
Press dDOCK to switch to the DOCK input.
2
Press rOPTION to display the OPTION
menu.
3
Use kCursor B / C to select “Connect” and
press kENTER. J2
4
Operate the Bluetooth component for
playback.
d
DOCK
kCursor B / C
kENTER
rOPTION
ENTER
DOCK
OPTION
SCENE
L
ME
ENHANCE
UR. DE
DE
STRAIGHTSLEEP
URE DIRECT
OVI
USI
RADI
M
T
E
OP-U
EN
DI
PLAY
UR
E
AIN
Z
NE 2
E
EIVER
CODE SE
NP
T
DMI
UDI
-
N
REE
NF
EM
RY
RESET
A
IRI
NER
TUN./C
ATE
R
d
r
k
SW
C
L
SL SR
R
SBL SBR
Completed
DOCK
VOL.
When pairing occurs correctly
Depending on Bluetooth components, a wireless
connection is established automatically or by
operating the Bluetooth components. In that case, it is
not necessary to carry out the following procedure.
“Not found” is displayed when there is an error
connecting. Check that the following conditions have
been satisfied, and try to establish a wireless
connection again.
• Both this unit and the Bluetooth component are paired.
• The Bluetooth component is switched on.
• The Bluetooth component is within 32 ft. (10 m) of the
Bluetooth wireless audio receiver.
To disconnect a wireless connection, repeat the same
steps, and in step 3, select “Disconnect.”
SW
C
L
SL SR
R
SBL SBR
BTconnected
DOCK
VOL.
When wireless connection is complete
J
1 : Depending on Bluetooth components, wireless connection is
carried out right after the pairing. In this case, “BT connected” is
displayed instead of “Completed.”
J
2 : “Disconnect” is displayed when a Bluetooth component has been
connected.
Comments to this Manuals