Zodiac TRI CHLORINE GENERATOR Installation Guide download pdf (Page 12)

5.3 Wiring to an external controller

IMPORTANT: e following instructions should be read in conjunction with the external controller

installation guide.

Remove the silver ‘dress’ cover by pressing on the sides and liing as illustrated below:

Remove the two screws that x the lower module to the main

unit (see below):

Gently remove the lower module from the TRi unit.

NOTE: If you are using the “TRi pH” module carefully disconnect the ribbon cable from the TRi unit (see the

“TRi pH” manual).

Remove the small white bung nearest to the centre of the TRi

lower panel:

Pass the controller wire through the hole (a grommet

may be needed depending on the size of the wire

being used).

Aach a cable tie to the controller cable as below in

order to prevent it from being pulled out.

Depending on the make of the external controller carry out the following connections for the cable:

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Zodiac TRI CHLORINE GENERATOR Installation Guide Page 12