Zodiac TRI CHLORINE GENERATOR Installation Guide download pdf (Page 17)

ON/OFF

Use safety

e Zodiac TRi must be installed by a pool professional. Its installation and use must comply with the

recommendations contained in this manual.

During any interventions on the pool’s hydraulic circuit and/or ltering system, remember to switch o the TRi

chlorinator rst ( buon) and then switch o ltering and the mains power supply.

During a lter backwash your TRi chlorinator MUST be turned o buon).

Do not scrape the electrodes with a brush or a metal object, do not distort them.

e maximum acceptable water temperature for water passing through the TRi cell should not be in excess of 40

°C for optimal production.

Water pressure in the TRi cell must not exceed 2.75 bar (275 kPa or 40 PSI).

Regularly check the TRi cell to make sure there is no debris that the lter may not have stopped and/or that there

is no scale deposit on the electrodes.

e TRi command box should not be installed above a source of heat of any type (pump, heating, radiator, closed

block…). It must also be mounted on a vertical wall in a dry ventilated place.

e life span of the TRi electronic equipment will be greatly increased if it is protected from direct sunlight and

humidity.

ON/OFF

1 2 ... 12 13 14 15 16 17 18

No comments

Zodiac TRI CHLORINE GENERATOR Installation Guide Page 17