Zodiac NOOSA REEF Instruction Manual download pdf (Page 55)

SKIMMER BOX INSTALLATION

SILICONE SEALANT REQUIRED (NOT SUPPLIED)

Important notice: Do not use the silicone sealants that are designed for use with windows and glass as they have an acidic cure

and can damage vinyl and some plastics. If the sealant smells like vinegar do not use it for this application.

A. Insert the double layer gasket around the cut out in the pool walll that there is a gasket layer on each side of the pool wall and

the screw holes line up (DO NOT UNDER ANY CIRCUMSTANCES CUT THE GASKET.)

B. Silicone sealer should now be applied to the back of the face plate, the front of the weir skimmer box, and to both sides of the

single rubber gasket in a single bead of approximately 5mm to assist in forming a leak proof seal between the liner and the

pool wall.

C. Use the screws supplied to locate the 4 corner screw holes of the skimmer box. Please make sure that the pool water depth is

at least 60cm before fitting the skimmer box as the liners can be under very high tension in the initial stages of filling the pool and

skimmer installation at this time can damage the liner.The four (4) corner screws are fitted from inside the pool, through the face

plate, single gasket double gasket and the pool wall, through into the skimmer box. Initially tighten screws 3 to four turns only.

D.With the four corner screws holding the skimmer box in place begin screwing in the upper and lower centre screws so that the

face plate starts to bend into a similar shape to the pool wall (do not over tighten screw.)continue fixing the screws from the upper

and lower centre position outward, as indicated by the numbering sequence below.

Tighten the four corner screws first once all others are in place.

E. Continue to fasten screws until all screws are tight, being careful not to over tighten the screws. Higher voltage cordless drills can

strip the thread in the skimmer box. Upon tightening a small amount of silicone sealant may be extruded from between the face

plate and the pool liner, this should be wiped with a rag as to remove any unsightly excess. Allow the recommended cure time

for the sealant before immersing in water.

F. The opening for the skimmer box can now be cut into the liner. It is important that this area be checked for leaks periodically.

(You can now cut the opening in the liner.)

G. Congratulations.The assembly/installation of your pool is now complete.You may now install the filtration motor/pump as per the

equipment suppliers instructions.

H. Operating instructions

1.To adjust inlet flow direction loosen knurled outer ring of eyeball fitting, move ball to desired position and tighten knurled ring

hand tight..

2.To clean basket, only remove skimmer cover and pull it out.

3. To attach vacuum cleaner hose, remove top cover. Put the vacuum adapter into the skimmer fill hose with water and insert

vacuum hose to the vac adapter.

1st

6th 3rd 2nd 4th 5th

8th

7th

5th

4th

2nd

3rd

6th

8th

7th

1st

1st1st

Skimmer Box

Skimmer Face Plate

Skimmer Box

Skimmer Face Plate

Pool Wall

1. Face plate position with 4 corner

locating screws in place

2. Face plate position with centre

screw almost completely fastened

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 63 64

Comments to this Manuals

No comments

Zodiac NOOSA REEF Instruction Manual Page 55

Comments to this Manuals