Zodiac Jandy EE-Ti Specifications download pdf (Page 17)

Page 14

Page 15

ATTENTION

After starting the AE-Ti heat pump, please

note that there is a 5 minute delay before the

compressor begins operation. The heat pump

display will show the remaining delay time in

minutes.

CAUTION

Keep all objects off the top of the heat pump.

Blocking air ow could damage the unit and

may void the warranty.

ATTENTION

Ne posez aucun objet sur le dessus de

l’appareil. Il pourrait empêcher la circulation de

l’air, ce qui risquerait d’endommager l’appareil

et d’annuler la garantie.

CAUTION

Do not use this heat pump if any part has

been under water. Immediately call a qualied

service technician to inspect the heater and

replace any part of the control system which

has been under water.

ATTENTION

N’utilisez pas cet appareil s’il a été plongé

dans l’eau, même partiellement. Faites

inspecter l’appareil par un technicien qualié et

remplacez toute partie du système de contrôle

et toute commande qui ont été plongés dans

l’eau.



 









 























SERVICE ACCESS

PANEL (5 SCREWS)

Figure 12. AE-Ti Heat Pump Front View

Section 5. Operation

5.1 Initial Start-up Precautions

Be sure that there is water in the pool and that the

surface level is above the skimmer or other inlet of the

pool’s filter system.

With any new pool or spa installation, operate

the filter pump with the heat pump off long enough

to completely clean the water. This will remove any

installation residue from the water. Clean the filter at

the end of this operation before starting the heat pump.

When raising the temperature of a cold pool, program

the time clock to run the pump continuously. This lets

the filter system and heat pump operate continuously

until the water reaches the temperature setting on the

temperature control. When that happens, the heat pump

will automatically shut off, but the filter pump will keep

running.

5.2 Operating the Controller

Your new AE-Ti heat pump is controlled by an

advanced microprocessor based controller that provides

a sophisticated yet simple interface to operate your heat

pump for maximum efficiency and enjoyment of your

pool. To locate the control buttons, see Figure 13.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Comments to this Manuals

No comments

Zodiac Jandy EE-Ti Specifications Page 17

Comments to this Manuals

Related products and manuals for Heat pumps Zodiac Jandy EE-Ti