Zodiac Jandy EE-Ti Specifications download pdf (Page 22)

Page 20

Page 21

6.3 Spring Start-Up

If your heat pump has been winterized, perform

the following steps when starting the system in the

Spring:

1. Uncover the heat pump and inspect the top and

sides for any debris or structural problems.

2. Close the petcock located on the lower front panel

of the heat pump.

3. Connect the water inlet and outlet unions located

on the lower front panel of the heat pump.

4. Turn on the lter pump to supply water to the

heat pump. Circulate water through the system

long enough to cycle all of the pool water through

the lter. Check for leaks in and around the heat

pump.

5. Turn on the electrical power to the heat pump at

the main breaker panel.

6.4 Inspection and Service

Jandy Heat Pumps are designed and constructed

to provide long performance life when installed and

operated properly under normal conditions. Periodic

inspections are important to keep your heat pump

running safely and efficiently through the years.

6.4.1 Owner Inspection

Jandy recommends that you inspect your heat

pump on a continual basis and especially after abnormal

weather conditions. The following basic guidelines are

suggested for your inspection:

1. Keep the top and surrounding areas of the heat

pump clear of all debris.

2. Keep all plants and shrubs trimmed and away from

the heat pump.

NOTE For spas, it is also necessary to perform water

changes in addition to chemical treatment. It is

recommended to change the spa water every

60 days for light usage and every 30 days if

usage is heavy.

6.2 Winterizing

CAUTION

Failure to winterize could cause damage to the

heat pump and will void the warranty.

ATTENTION

La garantie sera annulée si l’appareil n’est pas

hivernisé convenablement.

In areas where freezing temperatures occur, you

should protect your pump, filter, and heat pump from

the elements. Perform the following steps to completely

drain the heat pump (see Figure 14).

1. Turn off the electrical power to the heat pump at

the main breaker panel.

2. Shut off the water supply to the heat pump.

3. Disconnect the water inlet and outlet unions

located on the lower front panel of the heat pump.

4. Open the drain located on the lower front panel of

the heat pump to drain the remaining water from

the heat exchanger. Leave the drain open until the

unit is ready for seasonal start-up.

5. Cover only the top of the heat pump to prevent

debris from falling into the unit. Do not wrap the

sides of the heat pump with any plastic or other

material that will retain heat or moisture inside the

unit.

Water Inlet Union

Water Outlet Union

Petcock

(Leave open until unit

is ready to start-up)

Figure 14.

Winterizing the AE-Ti Heat Pump

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments

Zodiac Jandy EE-Ti Specifications Page 22

Comments to this Manuals

Related products and manuals for Heat pumps Zodiac Jandy EE-Ti