Zodiac Jandy EE-Ti Specifications download pdf (Page 7)

Page 4

Page 5

























      

    

    

    

Figure 1. Jandy AE-Ti Heat Pumps Dimensions

Correct installation is required to assure safe

operation. The requirements for Jandy heat pumps

include the following:

1. Field assembly (if required).

2. Appropriate site location and clearances.

3. Sufcient air ventilation.

4. Proper electrical wiring.

5. Adequate water ow.

This manual provides the information needed to

meet these requirements. Review all application and

installation procedures completely before continuing the

installation.

2.2 Location Requirements

2.2.1 Introduction

NOTE: Indoor installations require special

considerations for condensate drainage and

venting the cold air produced by the heat

pump. Contact the Jandy Heat Pump Technical

Service Department at (954) 970-4800.

CAUTION

When pool equipment is located below the pool

surface, a leak from any component can cause

large scale water loss or ooding. Waterpik

Technologies cannot be responsible for such

water loss or ooding or resulting damage.

ATTENTION

Lorsque l’équipement d’une piscine est situé

sous la surface de l’eau, une fuite provenant de

n’importe quel élément peut causer une perte

d’eau importante ou une inondation. Waterpik

Technologies n’est pas responsable des pertes

d’eau, des inondations ou des avaries causées

par une installation ou un entretien inadéquat.

Avoid placing the heat pump in locations where

it can cause damage by water or condensate leakage. If

this is not possible, provide a suitable drain pan to catch

and divert any leakage.

All criteria given in the following sections reflect

minimum clearances. However, each installation must

also be evaluated, taking into account the prevailing

local conditions such as proximity and height of walls,

and proximity to public access areas.

2.2.2 Clearances

The heat pump must be placed to provide

clearances on all sides for maintenance and inspection.

See Table 1.

At least 24” (61cm) access must be available in

front of the heat pump for service.

If the heat pump is to be installed in a garage

or under a vertical overhang, the unit must have a

minimum of 5 feet clearance from the top of the heat

pump.

This heat pump must be installed at least 5 feet

(1.52 meters) from the inside wall of the pool or spa

unless the heat pump is separated from the pool or spa

by a 5 foot high solid fence or other permanent barrier.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comments to this Manuals

No comments

Zodiac Jandy EE-Ti Specifications Page 7

Comments to this Manuals

Related products and manuals for Heat pumps Zodiac Jandy EE-Ti