Zodiac TRI CHLORINE GENERATOR Installation Guide download pdf (Page 11)

Select

Connecting to an external controller (Home automation)

If you use a centralised control system (or an external controller) to control your pool your TRi chlorinator must be

set to allow communications between the two appliances.

Example of a controller:

5.1 Seing the type of external controller

IMPORTANT NOTE: e controller type must imperatively be set before connecting the control cables to the

external controller box.

Turn the TRi on.

Wait for the end of the starting sequence.

Press the buon.

Use the keys to navigate to ‘EXT CONTROLLER’.

Press the key to access the controller menu.

Use the keys to select your external controller version.

Press to save your choice.

e TRi will display the main menu.

Press the key to return to the operational display.

NOTE : Your TRi chlorinator can only be connected to the controller models that are listed in the ‘EXT CONTROLLER’

menu. Do not connect the Tri to any other model of external controller.

Warning: users of Jandy ‘REV L’ or more recent versions

It is essential that the external controller seing be set to JANDY L/M if a Jandy Aqualink ‘Rev L’ controller or a more

recent version is to be connected. If the wrong seing is selected the Jandy Aqualink control unit may be damaged.

5.2 Precautions when wiring an external controller

IMPORTANT: e wiring of the controller should be carried out by an experienced pool specialist.

Before connecting or disconnecting any wires make sure the power supply to both the external controller and the

TRi unit has been cut o.

When the TRi chlorinator is connected to a controller it is in slave mode and responds to requests. In this case the

Timer seings are ignored and the chlorine production level cannot be changed. All the other ‘MENU’ functions are

still available except for ‘BOOST’ and ‘LOW’ modes.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Zodiac TRI CHLORINE GENERATOR Installation Guide Page 11