Zodiac Jandy EE-Ti Specifications download pdf (Page 23)

Page 20

Page 21

3. Do not use this heat pump if any part has been

under water. Immediately call a qualied

professional technician to inspect the heat pump

and replace any part of the control system which

has been submerged.

The heat pump will produce condensation (water)

while in operation. The heat pump base is designed to

allow the condensation to exit through the bottom drain

port when the unit is running. The condensation will

increase as the outdoor air humidity level increases.

Check the following at regular intervals to ensure proper

condensate drainage:

1. Visually inspect and clear the bottom drain ports

of any debris that could clog the ports.

2. Ensure that condensate water does not puddle

inside the heat pump

3. Ensure that condensate run-off is properly directed

away from the equipment pad to keep it from

undermining the pad.

During normal operation, the heat pump

produces three to five gallons of condensate per hour.

If condensate drainage is above this range during

operation or if water continues to drain from the base

when the heat pump is not in operation for more than an

hour, a leak in the internal plumbing may have occurred.

Call a qualified heat pump technician to investigate the

problem.

Keep the top air flow discharge and air flow intake

area clear of debris so the air flow though the heat pump

is not restricted. The cooler discharge air from the top

should not accumulate and be drawn into the side air

intake coils. Keep all plants and shrubs trimmed away

from the heat pump.

Make sure the front of the unit is accessible for

future service.

Keep lawn sprinkler heads from spraying on the

heat pump to prevent corrosion and damage. Use a

deflector if needed.

If the unit is installed under a very sharp roof pitch

or under a roof without a gutter, a gutter or diverter

should be fitted to prevent excessive water from pouring

down into the unit.

6.4.2 Professional Inspection

Inspections performed at least once a year by a

qualified technician are required to maintain your heat

pump’s safe and efficient operation. The following

basic safety checks must be performed.

1 Check for loose or broken wires and terminal

connections.

2. Verify the pressure switch operation. Turn the heat

pump OFF. Disconnect the power to the pump

time clock, or turn the pump time clock to an OFF

Figure 15. Heat Pump Operation Overview

position. Turn the heat pump back ON. The heat

pump must not come on.

3. Inspect the electrical controls, specically the

following:

a. High and Low limits

b. Pressure switch

c. Temperature control

4. Inspect the evaporator coil for blockage and clean

as necessary.

5. Check for spider webs or debris in the condensate

drain; clean if necessary.

6. Conduct a normal operating cycle and observe that

the unit operates properly.

Section 7. Professional Maintenance

and Service

7.1 Heat Pump Design

The Jandy Air Energy Heat Pump is one of the

most efficient ways to heat a pool or spa. The heat pump

transfers heat from the outside air to the pool or spa

water by means of an internal heat exchanger.

When the fan is turned on, warm air is drawn

through the refrigerant charged evaporator, turning

the cold liquid refrigerant to a warm gas. The gas then

flows through the compressor where it is compressed

resulting in a much higher temperature.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Comments to this Manuals

No comments

Zodiac Jandy EE-Ti Specifications Page 23

Comments to this Manuals

Related products and manuals for Heat pumps Zodiac Jandy EE-Ti