Zodiac Jandy EE-Ti Specifications download pdf (Page 6)

Page 4

Page 5

the absence of local codes, refer to the latest edition of

the National Electric Code (NEC) in the United States

and the Canadian Electric Code (CEC) in Canada for

installation.

1.5 Technical Assistance

Consult Jandy Technical Support Department or

your local Jandy dealer with any questions or problems

involving the specifications, installation, and operation

of your Jandy equipment. An experienced technical

support staff is ready to assist you in assuring the proper

performance and application of Jandy products. For

technical support call the Jandy Heat Pumps Technical

Service Department at (954) 970-4800

1.6 Materials Needed For Installation

1.6.1 Materials for All Installations

The following items are needed and are to be

supplied by the installer for all heat pump installations:

1. Plumbing connections (2”).

2. Level surface for proper drainage.

3. Suitable electrical supply line. See rating plate on

unit for electrical specications. A junction box is

not needed at the heat pump; connections are made

inside of the heat pump electrical compartment.

Conduit may be attached directly to the heat pump

jacket.

NOTE: Flex conduit is recommended for connecting

the electrical supply wires to the heat pump so

that the front panel may be removed easily for

servicing.

4. Electric cutout switch that will interrupt all power

to the unit. This switch must be within line of sight

of the heat pump.

5. Watertight conduit to run the electrical supply line.

1.6.2 Recommended Materials for

Installations

Jandy recommends installing isolation valves

on the inlet and outlet water connections for ease of

serviceability.

1.7 Specications

1.7.1 General Specications

Installation Location

Certified for use in:

USA

Canada

Mexico

Central and South America

Indoor/Outdoor

approved

Indoor/Outdoor

approved

Indoor/Outdoor

approved

Indoor/Outdoor

approved

Water Pipe/Heater Connection

Plastic 2” PVC (Unions

included)

Flow Rate

Maximum

Minimum

125 gpm

(475 lpm)

30 gpm

(110 lpm)

Maximum Working Water

Pressure

75 psi

Electrical Supply

Voltage Requirements

1-Phase

3-Phase

208/230 VAC 60Hz

208/230/380/460

VAC, 50/60 Hz,

(Model dependent)

Amperage Protection

Requirements

AE2000

AE2500

AE3000

1-Phase

40 A

50 A

3-Phase

30 A

1.7.2 Dimensions

See Figure 1 for a diagram showing the heat

pump’s dimensions and for dimensions to critical

connections.

Section 2. Installation Instructions

2.1 General Information

Install the Jandy heat pumps in accordance

with the procedures in this manual, local codes and

ordinances, and in accordance with the latest edition of

the appropriate national code. (See Section 1.4, “Codes

and Standards”.)

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments

Zodiac Jandy EE-Ti Specifications Page 6

Comments to this Manuals

Related products and manuals for Heat pumps Zodiac Jandy EE-Ti