Zodiac NOOSA REEF Instruction Manual download pdf (Page 34)

Continue by inserting the end of each wall

channel into

joiner plates. Ensuring that they are

firmly inser ted and

leaving a space of 13 mm

(ill. A) between each wall channel

of the

round sections. Insert and leave a 50 mm

Important:

The wall channels of the straight

sections

are shorter (1067 mm).

Install the

wall channels

by placing them on the inside of the braceless

the joiner plates will hold

the vertical sleeve on

either side (ill. C).

frames. In this way, the feet of

space on the straight side (ill.B).

ASSEMBLY

Note: The wall channels should be positioned on the mark of the radius

STEP 19.

NOTE:

Only the end radius wall channels are adjustable and have indexing pins.The intermediate wall channels side sections

are not adjustable and are used as the straight sides

You must now assemble the wall channels.This is a three step process.

STEP 1: Detach the indexing pins attached to the wall channel.

STEP 2: Identify on the reverse side of the wall channel (while loooking underneath the wall channel) the approximate radius of your pool

and insert the indexing pin into the corresponding hole - refer to illustration “A” above.

STEP 3: Turn the wall channel right side up and align once again the pin with the corresponding hole. Press down the wall channel onto the

pin to complete the assembly - refer to illustration “B” above. Repeat these steps for each wall channel and indexing system.

STEP 20.

13 mm

-13

50 mm

INDEX:

Hole (12) = 3.6mt Pools (w)

Hole (15) = 4.5mt Pools (w)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 63 64

No comments

Zodiac NOOSA REEF Instruction Manual Page 34