Zodiac NOOSA REEF Instruction Manual download pdf (Page 54)

SKIMMER BOX INSTALLATION

52

One piece return fitting installation this step

is not to be commenced until there is at

least 60cm of water in the pool.

Before attaching the return fitting to the

pool, it is necessary to cover the threads of

the return fittings with a thin layer of Teflon

tape to ensure a watertight seal.

1/ Using a small piece of cardboard push the

liner back against the metal pool wall to

locate the exact position of the circular cut-

out in the wall, and using a sharp knife

carefully cut a circular hole in the liner (from

the outside) approximately 3mm smaller

than the cut-out in the metal wall.

2/ Fit a cork gasket over the barrel of the

fitting and a rubber gasket between the pool

liner and the metal pool wall, and push the

fitting through the wall from the inside of

the pool.

3/ The remaining rubber gasket and the cork

gasket are now fitted over the barrel fitting

from the outside of the wall, with the rubber

gasket up against the pool wall, the lock nut

is now screwed onto the barrel and

tightened firmly to ensure a watertight seal,

care must be taken to ensure that the

locknut is not over tightened causing the

flange on the barrel to rotate and distort the

liner, if this occurs the lock nut should be

loosened, the gaskets repositioned and the

lock nut re tightened.

4/ The adjustable directional eyeball fitting,

can now be screwed into the face of the wall

return fitting.The outlet in this fitting (the

return to the pool) should face away from

the opening (the inlet) to the weir skimmer

assembly.

ONE PIECE RETURN FITTING

Universal quick snap

(2) P5346

Screws P7514

Eyeball return

P75042

Complete Skimmer

P5802

Cover P5315

Vacuum plate P5314

Skimmer basket P5316

Skimmer door P5317

Pool wall & liner

Double gasket P5318

Face plate P7506

Single gasket P7518C

Cover plate P73502

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 63 64

Comments to this Manuals

No comments