Zodiac NOOSA REEF Instruction Manual download pdf (Page 37)

WALL INSTALLATION

3.6m Wide Pools

5.94m x 3.66m and 7.08 x 3.66m Pools

4.5m Wide Pools

7.99 x 4.57m, 9.13 x 4.57m

6.85 x 4.57m and 11.41 x 4.57m pools.

13 mm

50 mm

STEP 24.

IMPORTANT NOTICE

Before you start to install the pool wall it is important that you take notice of where the skimmer box is to be installed (see

diagram below). Due to the fact that the wall joint must be located in a defined position on the oval end of the pool, it is at one of

these points that you should start to unroll the wall.There are two nuts/bolts/washers located approximately 10mm from the

bottom of the wall that will not fit into the bottom wall channel.These bolts need to be located in one end of the position(s)

marked (B) where the bottom wall channels are at the maximum spacing in the joiner plate and hence behind a vertical. Failure to

do this may result in damage to the pool wall.(Refer to diagram below for positions B)

Positions marked B.

are suitable for wall bolts

C Overhead view

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 63 64

No comments

Zodiac NOOSA REEF Instruction Manual Page 37