Zodiac NOOSA REEF Instruction Manual download pdf (Page 40)

When both ends of the wall are aligned, use two

or three phillips head screwdrivers, starting at the

bottom of the wall, to keep the wall aligned until

you have installed the bolts.

Screwdriver

Remove the resin upright located at the wall joint

using a screwdriver. To fasten the wall joint, it is

very important to use the washers provided.

Tighten the bolt heads on the inside of the pool

and the nuts and washers on the outside.

Ensure that all bolts and hole are used

(except as mention in step 24). Use the

bolts provided with the wall.

Once the wall joint has completely bolted,

replace the last resin upright and top deck,

without forgeting the base crown.

Assemble the 3/8” x 1/4” bolts, 1/4” nuts and 1/4” washers into the bolt hole provided and firmly tighten. It

is important to have the washers and nuts on the outside of the pool with the bolt head on the inside. Once

this has been done, remove any screwdriver burrs from the wall screws with a file. Cover the bolt

heads from top to bottom with duct tape.

Option 1 Option 2

WALL ASSEMBLY

STEP 28.

STEP 29.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

No comments

Zodiac NOOSA REEF Instruction Manual Page 40